Quick answer
Why does shisha charcoal smell when lit, and what does this factory check?
A smell at ignition can come from binder, volatile matter or storage; the factory fails a batch that smells or smokes on warming up. No laboratory result records smell, so compare problem pieces of coconut shell charcoal briquettes with your half of the approved sample on the same setup, and test a carton kept dry, before raising it within 14 days of arrival.
1. What ignition odor is
A smell at ignition is judged by the person lighting the piece, and no laboratory result states it.
Definition
ignition odor
Ignition odor is a smell given off by a charcoal briquette while it is lit and warming up, judged by the person lighting it; no laboratory result states it.
The smell at first light depends on the device, the airflow and the way the piece is lit as much as on the charcoal, so this site makes no absolute claim about it; see what this site never claims. A smell complaint is traced, source by source.
How facts on this page are confirmed is set out in the editorial and review policy.
2. Three likely sources
Three sources are checked: the binder, volatile matter and moisture taken up in storage.
| Source | What the published source says | At this factory |
|---|---|---|
| The binder | A 2025 peer-reviewed study reports that the combustion of briquettes, which often contain binding agents and additives, can cause higher carbon monoxide emissions. | Binder: tapioca starch, typically 1.5–3% of the mix |
| Volatile matter | FAO's handbook: high-volatile charcoal is easy to ignite but may burn with a smoky flame, and a low carbonization temperature raises volatile matter. | Shell charcoal accepted at 14% or less; newest report 12.33% as received |
| Storage | FAO: charcoal takes up moisture from humid air quickly. A 2024 study notes that lower moisture means more efficient burning and less smoke. | Leaves the oven at moisture of 2% at most; storage after delivery is the buyer's |
The binder enters the briquette at the mixing step, set out in milling and mixing.
3. The factory's warm-up check
A batch that smells or smokes on warming up fails at the factory.
That rule is one of four reasons a batch fails: smell or smoke on warming up, high ash, cracks or breakage and inconsistent size or density. The factory also times 3 pieces lit on an electric coil at its burn bench; how the warm-up check itself is run is not on file.
Note
What the warm-up rule covers
- It covers a batch, as it behaves on warming up at the factory.
- It does not cover storage after shipping, the device or the way a piece is lit in use.
Volatile matter is held at intake; the limit and the newest measured value are on the volatile matter page.
4. What to check before a claim
Before a claim, separate a charcoal problem from a storage or lighting one.
-
Step 1
Light it the way you tested the sample
Same heat, same setup. Use the heater, heating time, bowl and airflow of your sample test.
-
Step 2
Burn the approved sample beside it
The reference. Light your half of the approved sample in the same session.
-
Step 3
Check the storage
Moisture. Note whether the cartons were opened, damp or kept in humid air, and test pieces from a carton kept closed and dry beside them.
-
Step 4
Read the shipment's report
Volatile matter and moisture. Compare volatile matter and moisture on the shipment's laboratory report with earlier reports.
If the smell follows the charcoal, report it within 14 days of the arrival of the container at the buyer's warehouse. The setup is in the sample test protocol, and the route on the troubleshooting page and the claims and remedies page; the retained sample of the batch is what your report is compared with.
Questions buyers ask
Does the starch binder smell when it is lit?
Why did one carton smoke more than the sample?
Sources
- Simple technologies for charcoal making (FAO Forestry Paper 41), chapter 10: Using charcoal efficiently (opens in new tab), Food and Agriculture Organization of the United Nations — accessed
- Mencarelli, Greco and Grigolato (2025), Grilling and air pollution: how charcoal quality affects emissions, Air Quality, Atmosphere & Health 18, 1757–1770 (opens in new tab), Springer Nature — accessed
- Seetapong et al. (2024), Exploring binder efficacy in the fabrication of charcoal briquettes from palmyra palm and oil palm shells, BioResources 19(3), 5047–5057 (opens in new tab), BioResources, North Carolina State University — accessed