Quick answer
How is the shell charcoal milled, sieved and mixed with binder before it is formed?
Shell charcoal is ground in hammer mills, cleaned in a rotary sieve, then mixed with a tapioca starch binder before extrusion. The line for coconut shell charcoal briquettes runs 4 hammer mills, then a 10 m rotary sieve in 5 cleaning passes. The binder is tapioca starch, typically 1.5–3% of the mix. Sieve mesh, particle size and mixing time are not on file.
1. What binder mixing is
This station turns checked shell charcoal into a mix that can be formed.
Definition
binder mixing
Binder mixing is the production step in which milled and sieved shell charcoal is blended with a starch binder into the mix that is then formed into briquettes.
It sits between intake, described under shell charcoal sourcing, and extrusion. What is on file for it is short:
- The mills: 4 hammer mills.
- The sieve: a 10 m rotary sieve in 5 cleaning passes.
- The binder: tapioca starch, typically 1.5–3% of the mix.
How facts on this page are confirmed is set out in the editorial and review policy.
2. Milling and sieving
The charcoal is ground first and cleaned second, in that order.
-
Step 1
Milling
Charcoal to powder. The shell charcoal that passed intake is ground in 4 hammer mills.
-
Step 2
Sieving
Cleaning the powder. The milled charcoal then goes through a 10 m rotary sieve in 5 cleaning passes. The owner describes the passes as cleaning.
The mesh of the sieve and the particle size of the powder are not on file, so neither is stated here.
4. What this page does not state
Four details of this station are not on file, and the page leaves them out.
- The sieve mesh and the particle size of the milled charcoal.
- The mixer and its batch size.
- The water added and the mixing time.
- Any additive besides the binder.
Tip
Ask to see it
Live video audits and factory visits are welcome, so these can be asked about and shown on a live call from the line.
The mix then goes to forming, which is extrusion only, with single laser-cut molds: the next station is pressing and cutting.